Editor’s Note: This month, Jim Heaphy celebrates 20 years writing for KBDN. All of us at KBDN congratulate him on this milestone and thank him for his important contributions to the magazine over the past two decades.

It’s been 20 years since I started writing this column on countertop fabrication. I hope my readers have gained some useful understanding of countertop issues through my writing.

To commemorate this anniversary, I’m inviting my son, James, to collaborate with me on this column. James is a talented stone repair technician with valuable insights about how to avoid problems with natural stone countertops. He is also knowledgeable about solid surface, quartz, butcher block and concrete countertops.

Cracking and Rust

Sometimes a countertop fabrication technique intended to prevent a certain problem can inadvertently cause a more serious problem. Natural stones are brittle and the narrow strip of material that runs along a sink cutout or a cooktop cutout is obviously a potential weak spot, especially during the process of transporting or installing a countertop. If a countertop isn’t moved gingerly the stone could crack across that narrow strip.

The first time that we saw a different kind of problem, we were shocked. This countertop did not have a short crack across the narrow strip in front of the sink. Instead, there was a very long and ugly crack right down the center of the narrow strip in front of an undermounted stainless steel sink.

What could have caused such a failure? It seemed counter intuitive; the countertop should have cracked perpendicularly across that strip, if it cracked at all. Operating on the principle of boldness and self confidence, we agreed to try to solve the problem, hoping to learn more through the repair process.

What we learned was that the 30"-long crack was caused by an attempt to prevent a 3"-long crack. Stone fabricators use a reinforcement technique known as “rodding” to strengthen these thin parts of a countertop. While the countertop is upside down on a work bench, a groove is cut down the center of the strip parallel to the cutout. A reinforcing rod is placed into that groove, and encapsulated with an appropriate resin poured into the groove.

Tests conducted by the Marble Institute of America show that “threaded round steel rod significantly strengthens the stone by 50% in load and 600% in deflection.” All seems very good so far.